Danfoss ECL Comfort 210 Operating Manual page 66

Operating Guide ECL Comfort 210/296/310, application A232 / A332
Setting
P frost T (circulation pump, frost protection temp.)
P heat T (heat demand)
Max. flow T (Maximum flow temperature)
Delay
Add. function (Additional function, Relay 5 (X5))
Priority (priority for return temp. limitation)
Acc. output func. (Accessory output function, Relay 4 (X4))
Frost pr. T (frost protection temp.)
Open time
Close time
Tn (idle)
Supply T (idle)
Ext. input (external override)
Ext. mode (external override mode)
Activation, acc. T (Activation of cooling mode, based on
accumulated outdoor temperature value)
Upper difference
Lower difference
Delay, example
Lowest temp.
Filt. acc. room T (Filter for accumulated room temperature
value)
Filt. acc. outd. T (Filter for accumulated outdoor temperature
value)
Act., acc. room T (Activation of cooling mode, based on
accumulated room temperature value)
Room T influence (Room temperature influence in cooling
mode)
Humidistat, diff. (Humidistat, difference for switching)
Humidistat, post t. (Humidistat, post ON-time)
Humidistat, setp. (Humidistat, setpoint)
Dew p. T offset (Dew point temperature, offset)
Auto tuning
Motor pr. (motor protection)
Temp. min.
Temp. max.
Summer, cut-out (limit for heating cut-out)
Summer, cut-out (limit for heating cut-out)
Infl. - max. (room temp. limitation, max.)
Infl. - min. (room temp. limitation, min.)
Xp (proportional band)
Tn (integration time constant)
M run (running time of the motorized control valve)
Nz (neutral zone)
66 | © Danfoss | 2017.08
ID Page
1x077 100
1x078 101
1x079 113
1x080 114
1x083 109
1x085 81
1x089 110
1x093 101
1x094 93
1x095 94
1x096 94
1x097 94
1x141 101
1x142 102
1x144 104
1x147 114
1x148 114
1x149 115
1x150 115
1x153 105
1x154 105
1x156 106
1x157 74
1x158 110
1x159 111
1x160 111
1x164 71
1x173 94
1x174 95
1x177 72
1x178 72
1x179 91
1x179 106
1x182 74
1x183 75
1x184 95
1x185 96
1x186 96
1x187 96
Factory settings in circuit(s)
1 2
VI.JM.G2.02