Built-In Tri-Rate Mic - Juniper MX10 Hardware Manual

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Fiber-optic 10-gigabit small form-factor pluggable (XFP) transceivers:
Connector: Duplex LC/PC (Rx and Tx)
10GBASE-E (model number: XFP-10G-E-OC192-IR2)
10GBASE-L (model number: XFP-10G-L-OC192-SR1)
10GBASE-S (model number: XFP-10G-S)
10GBASE-Z (model number: XFP-10G-Z-OC192-LR2)
Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface
Specifications.
DWDM Tunable XFP transceivers:
Connector: Duplex LC/PC (Rx and Tx)
10GBASE-ZR (model number: XFP-10G-CBAND-T50-ZR)
DWDM supported wavelengths—see 10-Gigabit Ethernet DWDM Transceiver
Wavelengths
NOTE: XFP-10G-CBAND-T50-ZR is supported in Junos 11.2R2 and later
Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface
Specifications

Built-in Tri-Rate MIC

The built-in 48-port Tri-Rate MIC is available only on the fixed MX80 chassis (MX80-48T)
and is not replaceable. The built-in Tri-Rate MIC has the following components:
48 autonegotiating 10Base-T, 100Base-TX, or 1000Base-T Megabit Ethernet ports.
Autonegotiation between Gigabit Ethernet circuit partners.
Maximum transmission units (MTUs) of up to 9192 bytes.
Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45
connector.
Pinout: MDI/MDI-X.
Maximum distance: 328 ft (100 m).
Link LED, one green per port. For more information, see
MX5, MX10, MX40, and MX80 Modular Interface Card LEDs on page 33
Maintaining the MX5, MX10, MX40, and MX80 MICs on page 159
Troubleshooting the MX5, MX10, MX40, and MX80 MICs on page 170
Replacing an MX5, MX10, MX40, and MX80 MIC on page 118
Chapter 5: Line Card Components and Descriptions
Table 16 on page 33.
25