Brother 884-T20 Operation Manual page 58

c Press the automatic needle-threading
button while the needle bar move screen
appears.
d Touch to return to the previous
screen.
Memo
• In the embroidering screen, a blue frame
appears around the thread information box
of the selected needle bar.
■ Moving the needle bar to be
threaded to the position of
embroidery
You can move the needle bar in the embroidering
screen.
a Touch the key for the needle bar that you
wish to thread.
 The selected needle bar moves to the embroidering
position.
56
Note
• If the thread is not taut, it may come out of
the thread tension disc. After upper
threading is finished, check again to make
sure that the thread is correctly passed into
the thread tension disc. (Refer to step
page 52.)
Memo
• When changing one of the upper thread
colors, it is easy to re-thread by cutting the
thread currently being used between the
spool and the thread guide above the spool.
Place the new spool on the spool pin and tie
the end of the new thread to the end of the
previous thread. Then pull the thread
through to the needle. (Refer to page 96.)
■ Using the spool net
When using metallic thread or any other strong
thread, place the included spool net over the spool
before sewing.
If the spool net is too long, fold it once to match the
size of the spool before placing it over the spool.
It may be necessary to adjust thread tension when
using the spool net.
1 Spool net
2 Thread
e
on