Brother 884-T20 Operation Manual page 217

e Put a drop of oil onto the hook.
Front angle view
1 Punch a small hole in oil bottle.
2 Apply oil here.
• Use a pointed object to punch a small hole in the tip
of the included oiler before using it.
f Touch appeared in the following
screen.
 The race backs to its original position.
g After oiling, insert the bobbin case into the
hook, and then close the hook cover. (Refer
to page 34.)
■ Oiling the needle bars
Side view
From embroidering screen, select one needle bar at
a time. (Refer to page 56 for needle bar screen). Turn
the handwheel counterclockwise bringing the
needle bar to its lowest position. Put one drop of oil,
as high as possible on the needle bar above the felt
washer.
1 Apply oil here.
• Too much oil may drip onto sewing project.
Note
• Put a drop of oil onto the hook once a day
before use.
• Apply one drop of oil on the lower needle
bar above the felt washer every 40 – 50
hours of sewing time.
• Apply only sewing machine oil. Use of any
other type of oil may result in damage to the
embroidery machine.
• Do not apply too much oil. Fabric or thread
may get contaminated. If too much oil is
applied, wipe off any excess with a rag.
• If the thread breaks while sewing or the
operating noise of the hook becomes loud,
apply oil onto the race hook.
APPENDIX
7
215