Brother 884-T20 Operation Manual page 226

Sewing cannot begin from the specified
starting position.
Change the starting position or rehoop
the fabric and change the embroidering
position. (Refer to 85, 113.)
The needle bar case has stopped at an
incorrect position.
Touch to automatically reset the
needle bar case.
Another operation was performed
while the automatic needle-threading
mechanism was threading the needle.
Press the automatic needle threading
button, and then perform the other
operation after the needle is threaded.
(Refer to page 54.)
224
The needle has stopped at an incorrect
position.
Turn the handwheel so that the mark on
the handwheel is at the top.
The needle bar case motor has locked
up.
Touch to automatically reset the
needle bar case.
The pattern could not be saved because
the memory is full.
Delete some patterns.
The needle bar case could not be
moved to its initial position.
Touch to automatically reset the
needle bar case.
The automatic needle-threading
mechanism did not operate correctly.
Remove the thread entangled in the
automatic needle-threading
mechanism, and then touch
The memory capacity of the USB media
has been exceeded.
There is too much data in either the
machine or the USB media.
.