Chapter1 Getting Ready; Names Of Machine Parts And Their Functions; Front View - Brother 884-T20 Operation Manual

1
Chapter
After unpacking the machine, first refer to "Accessories" on page 19, and check that all listed accessories
are included. After checking that all accessories are included, the embroidery machine can be set up.
The setup of the machine and the various preparations required before starting to sew are described in
this chapter.

Names of Machine Parts and Their Functions

The names of the various parts of the sewing machine and their functions are described below. Before
using the sewing machine, carefully read these descriptions to learn the names of the machine parts.

Front view

1 Thread tension knobs
Adjust the tension of the thread.
2 Needle bar case
Moves to the left and right to move the needle to the
embroidering position.
3 Lower thread guide
4 Carriage
Attach the embroidery frame to the carriage. When the machine
is turned on or when the machine is embroidering, the carriage
moves forward, backward, left and right.
5 Hook cover/Hook
Open the hook cover, and then insert the bobbin case into the
hook.
6 Feet
Use the feet to adjust the height of the legs.
7 Sewing light
The brightness of the sewing light can be adjusted in the
settings screen. Refer to page 178.
8 Operation panel
GETTING READY
9 Spool stand
Put 6 thread spools to embroider.
0 Thread guide assembly support
A Thread guide
B Upper thread guide pretension knob
C Thread guide pins
D Middle thread guide
17