Exit With Save; Exit Without Save; Restore Factory Defaults - Inateck P6 User Manual

Exit with Save

"Exit with Save" barcode will emerge in this and the following chapters of manual, the
Inateck P6 scanner will exit setting mode once this barcode is scanned successfully.
Once the barcode is scanned successfully, the Inateck P6 Barcode Scanner will respond
with three chord sounds, and the LED2 indicator will be on with color becoming blue.

Exit without Save

"Exit without Save" barcode is suggested to scan when error setup occurs. And just like
the response of scanning barcode "Enter with Save", the Inateck P6 Barcode Scanner will
respond with three chord sounds, and the LED2 indicator will be on with color turning
blue if the barcode is scanned successfully.

Restore Factory Defaults

"Restore Factory Defaults" barcode is a special barcode, which the Inateck P6 Barcode
Scanner will respond with a short beep (high tone) after scanning. At this time, the
system of scanner could restore factory defaults, and there's no need to scan"Exit with
Save" barcode again.
"Restore Factory Defaults" barcode can be used under following circumstances:
1. The scanner doesn't work. For example, it cannot read/ scan any barcodes.
2. You forget the settings you did to the scanner before, and you don't want to be
affected by the forgotten settings when you use the scanner.
3. You are to use a function which is not usually used or is not the default setting of the
scanner.
Note: Most of the settings have factory defaults selection. The factory default value for
each setting is indicated by an asterisk "*".
Exit with Save
Exit without save
Restore Factory Defaults
11