Read Code With Specific Initial Characters Only - Inateck BCST-53 Instruction Manual

Enter Setup

Read Code with Specific Initial Characters Only

Under this mode you may set 1-6 digits as initial characters, and the scanner will
only recognize the barcodes with these initial characters. Please refer to the
Appendix I for the supported characters.
Steps to enable reading barcodes with initial characters "A" and "6" are as below:
1. Read the "Enter Setup" barcode.
2. Read the "Set the Special Initial Character" barcode.
3. Read the "A" barcode in Appendix I;
4. Read the "6" barcode in Appendix I;
5. Read the "Exit and Save" barcode.
Note: After you set the initial characters by steps above, the BCST-53 will only
recognize the barcodes with specific initial characters. If you want to disable the
function, please read the "Enter Setup" - "Remove the Restriction on Initial
Characters" - "Exit and Save".
Set Initial Characters Only Read the Barcodes
with Specific Initial Characters
(*) Remove the Restriction on Initial
Characters
Exit and Save
39