Displaying Ieee 802.1X Statistics And Status - Cisco Catalyst 2950 Software Configuration Manual

Chapter 9 Configuring IEEE 802.1x Port-Based Authentication
Beginning in privileged EXEC mode, follow these steps to configure IEEE 802.1x accounting after AAA
is enabled on your switch. This procedure is optional.
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3
aaa accounting dot1x default
start-stop group radius
Step 4 aaa accounting system default
start-stop group radius
Step 5
end
Step 6 show running-config
Step 7 copy running-config startup-config
Use the show radius statistics privileged EXEC command to display the number of RADIUS messages
that do not receive the accounting response message.
This example shows how to configure IEEE 802.1x accounting. The first command configures the
RADIUS server, specifying 1813 as the UDP port for accounting:
Switch(config)# radius-server host 172.120.39.46 auth-port 1812 acct-port 1813 key rad123
Switch(config)# aaa accounting dot1x default start-stop group radius
Switch(config)# aaa accounting system default start-stop group radius

Displaying IEEE 802.1x Statistics and Status

To display IEEE 802.1x statistics for all interfaces, use the show dot1x all statistics privileged EXEC
command. To display IEEE 802.1x statistics for a specific interface, use the show dot1x statistics
interface interface-id privileged EXEC command.
To display the IEEE 802.1x administrative and operational status for the switch, use the show dot1x all
privileged EXEC command. To display the IEEE 802.1x administrative and operational status for a
specific interface, use the show dot1x interface interface-id privileged EXEC command.
78-11380-12
Purpose
Enter global configuration mode.
Specify the port to be configured, and enter interface configuration mode.
Enable IEEE 802.1x accounting using the list of all RADIUS servers.
(Optional) Enables system accounting (using the list of all RADIUS
servers) and generates system accounting reload event messages when the
switch reloads.
Return to privileged EXEc mode.
Verify your entries.
(Optional) Saves your entries in the configuration file.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Displaying IEEE 802.1x Statistics and Status
9-25