Understanding Catalyst 2955 Switch Alarms - Cisco Catalyst 2950 Software Configuration Manual

Configuring Catalyst 2955 Switch Alarms
This section describes how to configure the different alarms for the Catalyst 2955 switch.
The alarms described in this chapter are not available on the Catalyst 2950 switch.
Note
For complete syntax and usage information for the commands used in this chapter, see the switch
command reference for this release.
This chapter consists of these sections:
•
•
•

Understanding Catalyst 2955 Switch Alarms

The Catalyst 2955 switch software monitors switch conditions on a per port or a switch basis. If the
conditions present on the switch or port do not match the parameters set by the user, the switch software
triggers an alarm or a system message. By default, the switch software sends the system messages to a
system message logging facility, or a syslog facility. You can also configure the switch to send Simple
Network Management Protocol (SNMP) traps to an SNMP server. You can configure the switch to
trigger an external alarm device by using the two independent alarm relays (major or minor). For more
information on how to configure the alarms, see the
on page
This section includes information about these topics:
•
•
•
•
78-11380-12
Understanding Catalyst 2955 Switch Alarms, page 3-1
Configuring Catalyst 2955 Switch Alarms, page 3-4
Displaying Catalyst 2955 Switch Alarms Status, page 3-11
3-4.
Global Status Monitoring Alarms, page 3-2
FCS Error Hysteresis Threshold, page 3-2
Port Status Monitoring Alarms, page 3-3
Triggering Alarm Options, page 3-3
C H A P T E R
"Configuring Catalyst 2955 Switch Alarms" section
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
3
3-1