Configuring Syslog Export - Cisco Catalyst 2950 Software Configuration Manual

Chapter 12 Configuring LRE

Configuring Syslog Export

If the syslog export feature is enabled, the switch sends the debugging messages to the LRE message
logging process and to the system message logging process.
Before enabling this feature, follow these guidelines:
•
•
Beginning in privileged EXEC mode, follow these steps to enable the switch to send debugging
messages to the LRE message logging process and to the system message logging process:
Command
Step 1 configure terminal
Step 2
lre syslog
Step 3
end
Step 4 show running-config
Step 5 copy running-config startup-config
To disable the syslog export feature, use the no lre syslog global configuration command. When you
enter this command, the switch sends debugging messages only to the LRE message logging process.
Beginning in privileged EXEC mode, follow these steps to specify the mode in which to log LRE events:
Command
Step 1 configure terminal
Step 2
interface interface-id
Step 3
logging lre {event | extended | normal}
Step 4 end
Step 5
show running-config
Step 6 copy running-config startup-config
To turn off the logging of events, use the no logging lre {event | extended | normal} interface
configuration command.
78-11380-12
Make sure that LRE logging is enabled.
Make sure that the console severity in the system message logging configuration is set to debugging.
For more information, see Chapter 26, "Configuring System Message Logging."
Purpose
Enter global configuration mode.
Enable the switch to send debugging messages from the LRE
logging process to the system message logging process.
Return to privileged EXEC mode.
Verify the change.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the LRE port to be configured, and enter interface
configuration mode.
Specify the mode in which to log LRE events:
event—Log events only.
•
extended—Log events and all possible parameters.
•
normal—Log events and some typical parameters.
•
Return to privileged EXEC mode.
Verify the change.
(Optional) Save your entries in the configuration file.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Configuring LRE Ports
12-23