Bridge Parameters; Port Parameters - GE P741 Technical Manual

P74x/EN GS/Na7
(GS) 3-28
1. To view the available parameters in the board that is connected, click the Get RSTP
2. To set the configurable parameters such as Bridge Max Age, Bridge Hello Time,
S.No Parameter

Bridge Parameters

GS
1. To read the RSTP bridge parameters from the board, go to the main window and click
2. Click the Get RSTP Parameters button. This displays all the RSTP bridge
1. To modify the RSTP parameters, enter the values and click Set RSTP Parameters.
2. To restore the default values, click Restore Default and click Set RSTP Parameters.
3. The grayed parameters are read-only and cannot be modified.

Port Parameters

This function is useful if you need to view the parameters of each port.
1. From the main window, click the device address to select the device and the RSTP
2. Select the Port Parameters tab, then click Get Parameters to read the port
3. Alternatively, select the port numbers to read the parameters.
Parameters button.
Bridge Forward Delay, and Bridge Priority, modify the parameter values and click
Set RSTP Parameters as below:
1 Bridge Max Age
2 Bridge Hello Time
3 Bridge Forward Delay
4 Bridge Priority
the device address to select the device. The RSTP Config window appears and the
default tab is Bridge Parameters.
parameters from the Ethernet board.
Config window appears.
parameters.
Default Value Minimum Value
(seconds) (seconds)
20
2
15
32768
Getting Started
MiCOM P741, P742, P743
Maximum Value
(seconds)
6 40
1 10
4 30
0 61440