Intermec EasyCoder PF2i Installation Instructions Manual page 55

<STX><SI>ws,DOWNLOAD_CA<ETX>
Start receiving the CA certifi cate via Zmodem and install it.
<STX><SI>ws,DOWNLOAD_CA,verysecret<ETX>
Start receiving the CA certifi cate via Zmodem and install it, using the
pass phrase "verysecret".
<STX><SI>ws,.SERVER_CN1,Printer33<ETX>
Sets common name 1 to "Printer33" (TTLS/PEAP only).
<STX><SI>ws,.SERVER_CN2,Printer34<ETX>
Sets common name 2 to "Printer34" (TTLS/PEAP only).
<STX><SI>ws,VALIDATE,ON|OFF<ETX>
Enables validation of the server certifi cate (TTLS/PEAP only).
All variables may be transmitted by means of:
<STX><SI>wt,[variable name]<ETX>
except EAP_PASS which always returns "****" if confi gured, CA_CERT
which transmits the name of the last certifi cate authority successfully
installed, and DOWNLOAD_CA which does not transmit anything.
An additional read-only variable is the supplicant state, STATE:
<STX><SI>wt,STATE<ETX>
Transmits the supplicant state: "Disabled", "Failing", "Authenticating",
or "Authenticated".
Note: If you start the printer with EAP type set to OFF and
then change the EAP type to TTLS, LEAP, or PEAP, you need
to reboot the printer for your new settings to take eff ect. Until
you reboot, STATE returns "Disabled".
802.1x supplicant state, EAP type, outer name, inner authentication,
installed root certifi cate, server common names, and server certifi cate
validation can be seen on the printer's web page and the network test
label.
EasyLAN Wireless Interface Kit Installation Instructions
Chapter 5 — Setup in IPL
51