Intermec EasyCoder PF2i Installation Instructions Manual page 37

Examples:
SETUP "wlan","WEP1","0x1138170147"
Sets key #1 (WEP 64, hexadecimal)
SETUP "wlan","WEP2","abcde"
Sets key #2 (WEP 64, alphanumerical)
SETUP "wlan","WEP3","0x123456789abcdef0123456789a"
Sets key #3 (WEP 128, hexadecimal)
SETUP "wlan","WEP4","Manufacturing"
Sets key #4 (WEP 128, alphanumerical)
SETUP "wlan","WEP2",""
Removes key #2
SETUP "wlan",".WEP_KEY","0"
Disables WEP
SETUP "wlan",".WEP_KEY","1"
Selects WEP key #1 for use in transmission (0-4 accepted)
SETUP WRITE/GET for WEP1-4 returns empty string if that key is
not confi gured, "****" otherwise.
It is not possible for any user to read the WEP key(s).
WEP Enabled/Disabled is shown on the printer's web page and the net-
work test label. WEP is deemed disabled if no key has been selected, or if
the selected key is not confi gured.
802.1x
Note: 802.1x functionality is supported only by Fingerprint
8.40 or later.
For increased security, IEEE 802.1x was introduced to wireless networks.
Th is method authenticates stations to the network (and in some cases
vice versa), so only authorized devices can access the network.
To increase the available memory, the supplicant subsystem is disabled if:
• 802.1x is disabled by setting EAP_Type to OFF.
• the printer has 8MB of SDRAM installed.
• there is no EasyLAN Wireless interface installed.
EasyLAN Wireless Interface Kit Installation Instructions
Chapter 4 — Setup in Fingerprint
33