Intermec EasyCoder PF2i Installation Instructions Manual page 23

• From the outside, insert the thin end of the light guide through the
small hole next to the antenna on the rear plate. Press the clear plastic
"lamp" in place. Connect the other end to the black plastic socket
(D1) at the top of the EasyLAN adapter board. Secure it with the
cable tie through the hole at the upper edge of the CPU board.
• Put back the cover over the electronics compartment.
• EasyCoder PF2/4i and PM4i only:
Route the cable from the display unit above the ribbon motor. Con-
nect the cable to connector J50 at the upper front corner of the CPU
board.
• Connect the power cord and switch on the power.
• Enter the Setup Mode and print the test label "Hardware Info" in
Fingerprint or "HW" in IPL to see if the printer detects the EasyLAN
Wireless interface board. For information on how to enter the Setup
Mode and print test labels, refer to the printer's user's guide.
• Set up the network parameters. Th ere are several methods:
- Connect the printer and a PC and run the EasyLAN Network
Setup wizard, which can be found on the attached CD-ROM.
Requires a PC running Windows 98 or later.
- Insert a CompactFlash card containing a confi guration fi le in the
printer and start it up. Confi guration Compact Flash cards can be
created using the EasyLAN Network Setup wizard on the attached
CD-ROM.
- Fingerprint:
Establish an RS-232 communication with the printer and set it
up using Fingerprint setup strings or setup fi les. IP address, subnet
mask, default router, and name server can also be set using the
printer's built-in keyboard. See Chapter 4. Only requirement on
the PC side is a terminal program that can transmit and receive
ASCII characters on an RS-232 line.
- IPL:
Establish an RS-232 communication with the printer and set it up
using IPL commands. You need a PC with a terminal program that
can transmit and receive ASCII characters. Select the method of
obtaining IP address, subnet mask, default router, and name server
automatically from the server using the printer's built-in keyboard.
Th is requires a server that supports DHCP and/or BOOTP. See
Chapter 5.
EasyLAN Wireless Interface Kit Installation Instructions
Chapter 2 — Physical Installation
19