Step-By-Step Instructions - Intermec EasyCoder PF2i Installation Instructions Manual
Easylan wireless
interface kit
Hide thumbs
Also See for EasyCoder PF2i:
- Service manual (270 pages) ,
- User manual (194 pages) ,
- Installation instructions manual (72 pages)
Table of Contents
Advertisement
Chapter 2 — Physical Installation
Step-by-Step Instructions
• Switch off the printer and disconnect the power cord.
• Disconnect all communication cables.
• Remove the cover over the electronics compartment as follows.
Th e electronic compartment contains wires and compo-
nents with dangerous voltage (up to 380V). Make sure that
the printer is switched off and the power cord is discon-
nected before the left-hand cover is removed.
EasyCoder PF2/4i Printers
• Open the right-hand door.
• Using a #T20 Torx screwdriver, remove the three screws and lift the
cover up so it disengages the bottom plate.
• Swing out the rear part of the cover so you can disconnect the console
cable from the CPU board.
14
EasyLAN Wireless Interface Kit Installation Instructions
Advertisement
Table of Contents
Need help?
Do you have a question about the EasyCoder PF2i and is the answer not in the manual?
Questions and answers