Configuration Commands - Stanford Research Systems SIM983 Operation And Service Manual

3 – 10
AWAK(?) z
Example:
3.4.5 Configuration commands
GAIN(?) f
Example:
OFST(?) f
Interface commands:
*RST - Reset to known state.
*IDN? - Identify.
*TST? - Does nothing.
*OPC(?) - Operation complete.
CONS(?) {z} - Console OFF/ON.
LEXE? - Last Execution Error.
LCME? - Last Communications Error.
LDDE? - Last Device-Dependent Error.
TOKN(?) {z} - Turn token mode OFF/ON.
TERM(?) {z} - Cmd line end (NONE, CR, LF, CRLF, LFCR).
Serial interface command (baud rate is always 9600):
PARI(?) {z} - Parity (NONE, EVEN, ODD, MARK, SPACE).
Keep Clock Awake
Set (query) the SIM983 keep-awake mode to z
Ordinarily, the clock oscillator for the SIM983 microcontroller is held
in a stopped state, and only enabled during processing of events
(Section 2.4). Setting AWAK ON forces the clock to stay running, and
is useful only for diagnostic purposes.
AWAK ON
Gain
Set (query) the amplifier gain to f . The module accepts signed
floating-point values in the ranges
19 99 The reset value is f
After a GAIN set command, the bandwidth is set to the value appro-
priate for the new gain. Gain queries do not alter the bandwidth.
GAIN 1.4232E1; GAIN?
+14.23
O set
Set (query) the o set of the amplifier to f volts . The module accepts
signed floating-point values in the range 10 000
reset value is f 0.000 .
Setting or querying the o set does not change the bandwidth.
Remote Operation
(OFF 0, ON 1) .
19 99 f
+1.00 .
SIM983 Scaling Amplifier
0 01 0 01 f
f 10 000 The