Stanford Research Systems SIM983 Operation And Service Manual page 37

3.4 Commands
CESE(?) [i,] j
Example:
OLSR? [i]
Example:
OLSE(?) [i,] j
Example:
PSTA(?) z
Example:
LBTN?
SIM983 Scaling Amplifier
Communication Error Status Enable
Set (query) the Communication Error Status Enable register [Bit i]
to j .
CESE?
2
Overload Status
Query the Overload Status Register [Bit i].
Upon executing an OLSR? query, the returned bit(s) of the OLSR reg-
ister are cleared.
OLSR?
3
Overload Status Enable
Set (query) the Overload Status Enable register [Bit i] to j .
OLSE 4
Pulse STATUS Mode
Set (query) the Pulse STATUS mode to z
When PSTA ON is set, all new service requests will only pulse the
STATUS signal LOW (for a minimum of 1 s). The default behavior
is to latch STATUS LOW until a *STB? query is received.
A reset does not alter PSTA. The value in boldface above is the
power-on value.
PSTA?
OFF
Last Button
Query the number of the last button pressed. The response is
LBTN? Last button
[polarity]
1
2 [gain ]
[gain ]
3
[o set ]
4
[o set ]
5
Both [gain ] and [gain ] (reset gain)
6
Both [o set ] and [o set ] (reset o set)
7
One of [gain ] and [polarity] (autocalibrate)
8
3 – 13
(OFF 0, ON 1) .