Figure 16: Wiring & Connecting - CipherLab 5000 Hardware Manual

Figure 16: Wiring & connecting
7. Attach connectors of the keyboard module, reader module, charger or battery
pack to receptacles on the PCB.
8. Follow the wiring instructions to insert every wire to a corresponding slot of the
terminal blocks
in to the PC board socket.
Connect line power.
Connect digital inputs and outputs.
Connect RS-232, if necessary
Connect RS-485, if necessary
9. If the Ethernet card
(two ends with RJ-45 connectors) to the Ethernet ports on the module and your
networking device.
Proceed to enable TCP/IP and set other networking parameters.
26
Installing 5000/5100:
Wiring & Connecting
. Tighten screws to secure wires. Then plug the terminal block
is installed, simply connect a standard networking cable
Setting up the terminal