Figure 14: Drilling Holes & Assembling Cables - CipherLab 5000 Hardware Manual

Figure 14: Drilling holes & assembling cables
1. Make use of the mounting template provided in the appendix, and drill four holes
in an appropriate location for installing the terminal:
Each hole shall be 6 mm in diameter and 21 mm in depth.
The four holes enclose a square of 120 mm x 120 mm.
2. Insert the four wall plugs (screw anchors for concrete surface) into the four holes.
Make sure each of them is completely inside a hole.
3. Pull cables through the cable entry hole
to organize the in-coming cables, and secure the holder to the pole
24
Installing 5000/5100:
Drilling Holes & Assembling Cables
. Apply the two-piece cable holder
Setting up the terminal
by screw.