Other Settings; Password Settings - Canon WUX500ST User Manual

Other settings

> [System settings] >
Lock operation with a password, set a password, reset counters for lamp or air filter
replacement, and access other settings and information.

Password settings

Disables the projector unless the correct password is entered.
Option
Off The projector can be used even if no password is entered.
On The projector cannot be used unless you enter your password.
To Cancel the Password
Turn off the projector and unplug the power plug.
Cancellation Hold down the MENU button on the side control and connect the power
on the plug. Make sure to keep holding down the MENU button until a beep
Projector sounds. When the projector beeps, the password is canceled. (The
entered password is also reset.)
Cancellation
To forcibly cancel the password from the remote control, in standby state
on the Remote
press the MENU button 3 times, then press the POWER button.
Control
• You cannot set [On] unless you have completed [Register password].
Once you set a password, the password entry screen appears at power-on.
Enter a 4 digit password.
Enter the password using the
If the password is valid, the projection starts. If you enter a wrong password three times,
the power will be turned off.
• The projector also goes off after three minutes of inactivity on the password input
screen.
[Other settings]
[ ] / [ ] / [ ] / [ ]
111
Menu Description
Function
buttons.