SCARABEO 125 i.e. - 200 i.e.
REAR BRAKE
•
Remove the rubber protection cover of
the bleeding valve «4».
•
Insert a transparent plastic pipe in the
bleeding valve «4» of the rear brake
calliper and insert the other end of this
pipe into a container to collect the fluid.
•
Quickly press and release the rear
brake lever several times and then
keep it fully pressed.
•
Loosen the bleeding valve 1/4 of a turn
so that the brake fluid flows into the
container. This will release tension on
the brake lever and will make it go to
the end of stroke.
•
Repeat the operation until the fluid
draining into the container is air-bubble
free.
NOTE
WHILE PURGING THE HYDRAULIC SYSTEM, FILL THE
RESERVOIR WITH THE NECESSARY QUANTITY OF
BRAKE FLUID. CHECK THAT, DURING THE OPERATION,
THERE IS ALWAYS BRAKE FLUID IN THE RESERVOIR.
•
Screw the bleeding valve and remove the pipe.
•
Top-up the reservoir until the correct brake fluid level is obtained.
•
Refit the rubber protection cover.
BRAKE FLUID CHANGE
•
Remove the rubber protection cover.
•
Insert a transparent plastic pipe on the
bleeding valve «1-2» of the calliper and
insert the other end of the pipe into a
container to collect the fluid.
•
Loosen the bleeding valve «1-2» ap-
proximately one turn.
NOTE
CHECK THAT, DURING THE OPERATION, THERE IS AL-
WAYS BRAKE FLUID IN THE RESERVOIR. OTHERWISE, IT
WILL BE NECESSARY TO PURGE THE AIR AT THE END
OF THE OPERATION.
Braking system
BRAK SYS - 179