Replacing The Drive Of A Basic Device - Siemens simatic ipc227e Operating Instructions Manual

Maintaining and repairing the device
6.3 Installing and removing hardware
6.3.2

Replacing the drive of a basic device

The procedure only applies to the basic device: Carry out the procedure if you want to
replace the hard disk drive with an SSD and vice versa or in the case of a fault.
Read the information in section "Repair information (Page 63)".
Requirement
● The device is open.
● A hard disk drive or an SSD
● A T10 screwdriver
Procedure - removing
68
Pull out the connection plug.
Lay down the device's rear panel
including the drive.
Remove the indicated screws.
Remove the drive rack and take
out the SSD.
Operating Instructions, 11/2016, A5E35782395-AB
SIMATIC IPC227E