Siemens simatic ipc227e Operating Instructions Manual page 101

Ports
COM
USB
LAN interface X1 P1, RJ45
LAN interface X2 P1, RJ45
Keyboard, mouse
In the BIOS setup, you can configure support for RS232 or RS22/RS485 for each COM port.
1
Available parameters:
- Autodirection
Termination can be set in BIOS.
2
For unique labeling, the LAN interfaces are numbered on the enclosure. The numbering by the
3
operating system can differ.
Teaming can be set and initiated in the configuration interface. In teaming operation, jumbo
4
frames, e.g. for the camera application, are not supported
Teaming is not possible in connection with Windows 10.
See also
Permitted mounting positions (Page 29)
SIMATIC IPC227E
Operating Instructions, 11/2016, A5E35782395-AB
3
3
- Onboard termination
- Half-duplex or Full-duplex
RS 232 , max. 115 Kbps, D-sub connector, 9-pin
• 1
RS 485 /RS 422 (optional), max. 115 Kbps, D-sub con-
• 1 2 1
nector, 9-pin
3 × USB 2.0, high speed/high current,
maximum of 2 can be operated in high-current mode at the
same time, max. 6 W
1 × USB 3.0, high current
You can find additional information in the section "Power re-
quirements of the components".
Intel LAN Controller Springville i210
10, 100, 1000 Mbps, teaming
Intel LAN Controller Springville i210
10, 100, 1000 Mbps, teaming
Connection via USB port
Technical specifications
7.4 Technical data
4
4
101