Step 1. Removing the Burner Box Glass
Loosen but do not remove the two retaining screws (A) for the bottom burner box glass clamp (B). While supporting
the burner box glass panel (C) in place, completely unscrew and remove the two retaining screws (D) and the top
burner box glass clamp (E). Then lift burner box glass panel (C) away and place it safely aside where it can not
get damaged.
D
E
G
Step 2. Unpacking the Log Set & Granules Satchel
Retrieve the foam packaging (F) containing the log set (G) and the burner granules (H) that was removed earlier
prior to the heater engine installation.
The satchel containing the burner granules (Q) is taped to the outside of the foam packing
that contains the log set. Ensure that you locate and remove the satchel before discarding the
packaging material.
IMPORTANT
Carefully unpack the log set (G) from the packaging material (F) and inspect for damage. If ANY damage is
evident DO NOT continue with installation and contact your supplier for advice.
Rinnai
BURNER MEDIA INSTALLATION
D
A
C
B
F
A
H
ENSURE TO LOOSEN BOTH
RETAINING SCREWS
25
A
B
THE LEFT AND RIGHT
A
..
..
RIBF25 OIM