How To Order - Danfoss VLT HVAC Design Manual

®
VLT HVAC Drive Design Guide

4 How to Order

4.1.1 Drive Configurator
It is possible to design a frequency converter according to the application
requirements by using the ordering number system.
For the frequency converter, you can order standard drives and drives
with integral options by sending a type code string describing the product
a to the local Danfoss sales office, i.e.:
FC-102P18KT4E21H1XGCXXXSXXXXAGBKCXXXXDX
The meaning of the characters in the string can be located in the pages
containing the ordering numbers in the chapter
In the example above, a Profibus LON works option and a General pur-
pose I/O option is included in the frequency converter.
Ordering numbers for frequency converter standard variants can also be
located in the chapter How to Select Your VLT
From the Internet based Drive Configurator, you can configure the right
frequency converter for the right application and generate the type code
string. The Drive Configurator will automatically generate an eight-digit
sales number to be delivered to your local sales office.
Furthermore, you can establish a project list with several products and
send it to a Danfoss sales representative.
The Drive Configurator can be found on the global Internet site:
www.danfoss.com/drives
.
Example of Drive Configurator interface set-up:
The numbers shown in the boxes refer to the letter/figure number of the
Type Code String - read from left to right. See next page!
How to Select Your VLT
.
.
MG.11.B9.02 - VLT ® is a registered Danfoss trademark
Product groups 1-3
Frequency Converter 4-6
series
Power rating
8-10
Phases 11
Mains Voltage 12
Enclosure 13-15
Enclosure type
Enclosure class
Control supply volt-
age
Hardware configu-
ration
RFI filter
16-17
Brake 18
Display (LCP) 19
Coating PCB 20
Mains option
21
Adaptation A 22
Adaptation B 23
Software release 24-27
Software language 28
A options
29-30
B options 31-32
C0 options, MCO 33-34
C1 options 35
C option software
36-37
D options 38-39
4 How to Order
4
65