Table of Contents
Advertisement
6
61
18
61
18
3
Step 2
Connect the Sensor Wire II (72) from the Right Handlebar Support Tube (4) to the wire
that comes from the Computer (53). It is recommended to have a second person assist
with this step. One person should hold the Computer (53) in place while the other person
connects the sensor wires.
Insert the Computer (53) onto the Left and Right Handlebar Support Tubes (3, 4) using
eight M8x55 Hexagon Socket Head Cap Bolts (61) and eight Ø8Flat Washers (18).
Tighten bolts with the 5mm Allen Wrench with Phillips Screwdriver provided.
Place the Safety Tether Key (79) onto the Computer (53).
IMPORTANT: While sliding the computer onto the right and left handlebar support tubes,
make sure the wires are installed inside the right and left handlebar support tubes and pay
attention not to pinch the wires.
NOW PLEASE FULLY TIGHTEN ALL BOLTS INSTALLED IN STEP 1 WITH THE
TOOLS PROVIDED.
Hardware:
(18) Flat Washer Ø8
53
73
61
72
18
61 18
4
8 PCS
79
Tool:
5mm Allen Wrench with
Philips Screwdriver
(61) Hexagon Socket
Head Cap Bolt M8x55
8 PCS
10
Advertisement
Table of Contents
