Installing Memory; How To Install Memory; Memory Support - Supero MicroCloud 5038ML-H12TRF User Manual

S S
UPER ERVER 5038ML-H12TRF User's Manual
5-6

Installing Memory

Caution: Exercise extreme care when installing or removing DIMM modules to prevent
any possible damage to the DIMMs or their sockets

How to Install Memory

1. Insert the desired number of DIMMs into the memory slots in the following
order: DIMMA2, then DIMMB2, DIMMA1, DIMMB1. Pay attention to the notch
along the bottom of the module to prevent incorrect installation.
2. Insert each DIMM module vertically push down until it and snaps into place.
Repeat to install more memory, if needed. See instructions on the next page.

Memory Support

Each X10SLE-F supports up to 32GB of Unbuffered (UDIMM) ECC DDR3-
1600/1333/1066 memory in four DIMM slots. Only VLP (Very Low Profi le) DIMMs
are supported. Please refer to the product page on our web site for possible updates
to memory support.
To Install: Insert
module vertically
and press down
until it snaps into
place. Pay attention
to the alignment
notch at the bottom.
To Remove:
Use your thumbs to
gently push the re-
lease tabs near both
ends of the module.
This should release
it from the slot.
Figure 5-2. DIMM Installation
Notch
Release Tab
Top View of DDR3 Slot
5-8
Front View
Notch should align
Release Tab
with the receptive
key point on the slot.
Notch