Table of Contents
Advertisement
S
S
UPER
ERVER 5038ML-H12TRF User's Manual
VGA Enable/Disable (JPG1)
JPG1 allows the user to enable the
onboard VGA connector (through the
KVM). Close pins 1~2 to enable the
VGA. The default setting is Enabled.
Watch Dog RST/NMI Selection
(JWD1)
Watch Dog (JWD1) is a system moni-
tor that can reboot the system when a
software application hangs. Close pins
1~2 to reset the system if an applica-
tion hangs. Close pins 2~3 to generate
a non-maskable interrupt signal for the
application that hangs. See the table on
the right for jumper settings. Watch Dog
must also be enabled in the BIOS.
ME Recovery
Set Jumper JPME1 to select ME Firm-
ware Recovery Mode, which will limit
system resource for essential function
use only without putting restrictions on
power use. In the single operation mode,
online upgrade will be available via Re-
covery mode. See the table on the right
for pin defi nitions.
Manufacturer Mode Select
Close this jumper (JPME2) to bypass
SPI fl ash security and force the system
to use the Manufacturer Mode, which
allows the user to fl ash the system fi rm-
ware from a host server to modify system
settings. See the table on the right for
jumper settings.
VGA Enable/Disable
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Watch Dog
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
ME Recovery
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
ME Mode Select
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
5-18
Defi nition
Enabled
Disabled
Defi nition
Reset
NMI
Disabled
Defi nition
Normal
ME Recovery
Defi nition
Normal
Manufacture Mode
Advertisement
Table of Contents
