Super Io Configuration - Viglen Vig430p Manual

 ASPM Support
This feature allows the user to set the Active State Power Management (ASPM) level for a PCI-
E device. Select Force L0s to force all PCI-E links to operate at L0s state. Select Auto to allow
the system BIOS to automatically set the ASPM level for the system. Select Disabled to disable
ASPM support. The options are Disabled, Force L0s, and Auto.
o Warning: Enabling ASPM support may cause some PCI-E devices to fail
 Slot 1~6 OPROM
Select Enabled to enable Option ROM support to boot the computer using a device installed
on the slot specified above. The options are Enabled and Disabled
 Onboard LAN Option ROM Select
Select iSCSI to use the iSCSI Option ROM to boot the computer using a network device.
Select PXE (Preboot Execution Environment) to use a PXE Option ROM to boot the
computer using a network device. The options are iSCSI and PXE
 Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM
Select Enabled to enable the onboard LAN1 Option ROM~LAN4 Option ROM. This is to
boot the computer using a network device. The default setting for LAN1 Option ROM is
Enabled. The default setting for LAN2 Option ROM is Disabled.
 Network Stack
Select Enabled enable PXE (Preboot Execution Environment) or UEFI (Unified Extensible
Firmware Interface) for network stack support. The options are Enabled and Disabled.

Super IO Configuration

 Super IO Chip
Displays the Super IO chip type
 Serial Port 0, Serial Port 1 Configuration
The submenus allow the user to configure the following settings for Serial Port 0 and Serial
Port 1:
o Serial Port
Select Enabled to enable a serial port specified by the user. The options are
Enabled and Disabled
o Device Settings
This feature indicates whether or not a reset is required for a serial port specified
o Change Settings
This option specifies the base I/O port address and the Interrupt Request address
of Serial Port 1 and Serial Port 2. Select Disabled to prevent the serial port from
accessing any system resources. When this option is set to Disabled, the serial
port becomes unavailable. The default setting is Auto.
Vig430P Motherboard Manual
82