Viglen Vig430p Manual page 23

Table 4: GLAN Jumper
Function/Mode
(Default)
Enable
Disable
Watch Dog Enable/Disable Jumper (JWD)
JWD controls the Watch Dog function. Watch Dog is a system monitor that can reboot the
system when a software application is "hung up". The table below describes the jumper settings.
Table 5: Watch Dog Jumper
Function/Mode
(Default)
Reset
NMI
Disable
2
I C Bus to PCI Slots Jumper (JI
2 2
Jumpers JI C1/JI C2 allows you to connect the System Management Bus (I
table below describes the jumper settings.
2
Table 6: I C Bus to PCI slots Jumper
Function/Mode
Enables
(Default)
Disable
Jumper Setting
1-2
2-3
Jumper Setting
1-2
2-3
Open
2 2
C1/JI
Jumper Setting
Closed
Open
Vig430P Motherboard Manual
Enables onboard LAN controller, this may also be
controlled via additional BIOS setting.
Disables onboard LAN controller. If set to disabled
this may not be enabled via additional BIOS
setting.
This will cause WD to reset the system if an
application is hung up.
This will generate a non-maskable interrupt signal
for the application that is hung up
This disables the Watch Dog feature
C2)
This enables the System Management Bus (I
to PCI slots connection.
This disables the System Management Bus (I
to PCI slots connection.
Configuration
Configuration
2
C) to PCI slots. The
Configuration
2
C)
2
C)
22