Viglen Vig430p Manual page 24

Front Panel Audio Control Jumper (Audio FP)
When front panel headphones are plugged in, the back panel audio output is disabled. This is
done through the FP Audio header (FP Audio). If the front panel interface card is not connected
to the front panel audio header, jumpers should be left blank. The table below describes the
jumper settings.
Table 7: Front Panel Audio Jumpers (Front panel audio)
Function/Mode
Front panel audio
Table 8: Front panel Audio Connector
Pin Signal name
1 MIC_IN
3 MIC_BIAS
5 RIGHT_OUT
7 Ground
9 LEFT_OUT
Jumper Setting
Open
Pin
2
4
6
8
10
Vig430P Motherboard Manual
In this open state there is no FP Audio connection
connected. Audio line out and mic in signals are
available for front panel audio connectors on this
connector when a FP Audio connection is installed
Signal name
Ground
+5V
RIGHT_IN
Key
LEFT_IN
Configuration
23