Viglen Vig430p Manual page 58

Table 18: POST code description (Continued)
POST Code
D8h
D9h
DEh
The following are for boot block in Flash ROM
Table 19: POST code description
POST Code
E0h
E1h
E2h
E3h
E4h
E5h
E6h
E7h
E8h
E9h
EAh
EBh
ECh
EDh
EEh
EFh
F0h
F1h
F2h
F3h
F4h
F5h
F6h
F7h
Note:
If the BIOS detects error 2C, 2E, or 30 (base 512K RAM error), it displays an additional word-
bitmap (xxxx) indicating the address line or bits that failed. For example, "2C 0002" means
address line 1 (bit one set) has failed. "2E 1020" means data bits 12 and 5 (bits 12 and 5 set)
have failed in the lower 16 bits. The BIOS also sends the bitmap to the port-80 LED display. It
first displays the checkpoint code, followed by a delay, the high-order byte, another delay, and
then the loworder byte of the error. It repeats this sequence continuously.
Alert Standard Format initialization
Late init for IPMI
Log error if micro-code not updated properly
Initialize the chipset
Initialize the bridge
Initialize the CPU
Initialize system timer
Initialize system I/O
Check force recovery boot
Checksum BIOS ROM
Go to BIOS
Set Huge Segment
Initialize Multi Processor
Initialize OEM special code
Initialize PIC and DMA
Initialize Memory type
Initialize Memory size
Shadow Boot Block
System memory test
Initialize interrupt vectors
Initialize Run Time Clock
Initialize video
Initialize System Management Manager
Output one beep
Clear Huge Segment
Boot to Mini DOS
Boot to Full DOS
Vig430P Motherboard Manual
Description
Description
57