Viglen Vig430p Manual page 26

These connectors are for the network activity LED. Connect the NIC LED cables to this
connector. Anytime a network cable is connected to a NIC the LED will light up.
E- Overheat/Fan Fail LED (OH)
This 2-pin connector is for the advanced warning of chassis overheating or fan failure. If the
system is overheating the LED will stay on, if a fan fails the LED will flash constantly.
F- Power Fail LED
This 2-pin connector is for the power stability for the system. If systems does not have the
required amount of power the LED will light up.
G- Reset Button
This 2-pin connector is for the chassis-mounted reset button for system reboot without turning
off the system power.
H- Power Button
This connector is for the system power button. Pressing the power button turns the system on
or puts the system in sleep or soft-off mode depending on the BIOS settings. Pressing the
power switch for more than four seconds while the system is ON turns the system OFF.
Vig430P Motherboard Manual
25