Step 11 Connect Water Supply; Step 12 Connect Power - Monogram 36” Installation Instructions Manual

Installation Instructions - Standard Installation
STEP 11 CONNECT WATER
SUPPLY
WARNING
Connect to potable water supply
only. A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 psi (275-827 kilopascals).
WARNING
ELECTRIC SHOCK HAZARD
Attach tubing clamp using existing hole only. DO NOT
drill into the refrigerator.
AVERTISSEMENT
alimentation d'eau potable seulement. Une alimentation
d'eau froide est requise pour faire fonctionner
la machine à glaçons et le pichet à remplissage
automatique. La pression d'eau doit se situer entre 40
et 120 psi. (275 à 827 kPa).
AVERTISSEMENT
Fixez le collier de serrage dans le trou présent seulement.
NE PERCEZ PAS dans le réfrigérateur.
ADVERTENCIA
suministro de agua potable únicamente. Se requiere
un suministro de agua fría para el funcionamiento de la
máquina de hielos automática y de la jarra de llenado
automático. La presión del agua deberá estar entre 40
y 120 p.s.i. (275 – 827 kPa).
ADVERTENCIA
Adhiera la abrazadera de la tubería usando el agujero
existente únicamente. NO perfore el refrigerador.
• Locate and bring
tubing to the front of
the cabinet.
• Turn the water on to
flush debris from line.
Run about a quart of
water through tubing
into a bucket, then
shut off water.
Copper Tubing:
• Slip a 1/4" nut and
ferrule (provided)
over both ends of the
copper tubing. Insert tube into the union fitting on the
unit and tighten nut to union.
• Turn on the water to check for leaks.
31-1000452 Rev. 1
Raccordez l'appareil à une
RISQUE DE DÉCHARGE
ÉLECTRIQUE
Realice la conexión a un
PELIGRO DE DESCARGA
ELÉCTRICA
Refrigerator
House
Water Supply
Water Supply
STEP 11 CONNECT WATER
SUPPLY (Cont.)
SmartConnect ™ Tubing:
NOTE: The only Monogram-approved plastic tubing is
supplied in the SmartConnect
Do not use any other plastic water supply line because
the line is under pressure at all times. Other types of
plastic may crack or rupture with age and cause water
damage to your home.
• Insert the molded end of the tubing into the
refrigerator connection. Tighten the compression nut
until it is just hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.
NOTE: Make sure excess tubing length does not
interfere with drawer closing or toekick installation.

STEP 12 CONNECT POWER

• Check to be sure the power cord is plugged into the
receptacle.
Electrical Outlet
• Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights are on.
• The temperature controls are preset at 37°F (2.78°C)
for the fresh food section and 0°F (-17.78°C) for the
freezer.
• Allow 24 hours to stabilize before making
adjustments.
21
™ Refrigerator Tubing kits.