Step 3 Level; Step 4 Connect Power; Step 5, Slide Product Into Cutout; Step 6 Set Temperature Controls - Monogram ZIDI240 Installation Instructions Manual

STEP 3 LEVEL

Use an adjustable wrench to turn and raise or lower the
leveling legs.
• Measure floor to countertop height inside the opening.
Adjust leveling legs until the product is approximately
1/8" less than countertop height.
INSTALLATION TIP:
Measure floor to underside of countertop inside
the opening.
• If the room floor is higher than the floor inside the
opening, adjust the rear leveling legs to approximately
1/8" less than the opening height. Screw front leveling
legs all the way in to shorten the height at the front.
This will allow you to slightly tip the unit into the
opening. Once the unit is in the correct position,
the front legs can be adjusted to level the product.

STEP 4 CONNECT POWER

• Connect power cord plug to a properly grounded
receptacle.
• Check to make sure power is on by opening a drawer
to see if interior light turns on.
• The interior fan runs all the time except when a drawer
is open.
See the Owner's Manual for further explanation of the
fan.
10
Installation Instructions
Turn Right to Lower
Turn Left to Raise
STEP 5 SLIDE PRODUCT INTO
THE CUTOUT
NOTICE: Do not push against the drawer panels with
your knees. Do not push or lift the unit by the drawer
handles. Damage may occur!
• Open one of the drawers and gently push the unit
back into the opening with your hands against the
sides. Be careful not to entangle power cord.
• Check again to be sure the unit is level. Adjust the
leveling legs until the unit is resting firmly against
the bottom of the counter to prevent rocking or
movement during operation.
• If alignment with adjacent cabinetry is an issue, use
a shim to secure the unit against the underside of the
countertop.
STEP 6 SET TEMPERATURE
CONTROLS
• The temperature controls are preset. Refer to the
Owner's Manual for more information. Allow 12–24
hours for the temperature to stabilize.
NOTE: The Double-Drawer Refrigerator operates very
quietly. You may not notice the unit running, and when
first installed, the fans and motor may not come on
immediately – this is normal. If the display is lit and the
light is working, the unit is operating.
31-1000643