Step 7. Alternate Anti-Tip Procedure; Step 8 Secure Refrigerator To Cabinetry - Monogram ZIPP360NHSS Installation Instructions Manual

STEP 7 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 130°, you may change the door swing to a 90°
opening. Skip this step if door opening is satisfactory
for your installation situation.
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover trim
and rotate off.
• Use pliers to unscrew door stop and reinstall into the
90° position.
Remove
Wire Cover
Trim Screws
• Reinstall the wire cover trim.
Installation Instructions
14
STEP 8 SECURE REFRIGERATOR
TO CABINETRY
Whenever possible, perform this step in addition to the
Anti-Tip Procedures for anti-tip security. The refrigerator
must be secured to prevent tipping.
• Raise the grille panel to access case trim.
• Drill hole in trim and drive screw through the trim into
adjacent cabinet.
• Follow the same procedure on the opposite side.
Drive screws through case trim
and into adjacent cabinets.