Step 3: Install Side Panels; Step 4: Roll Unit Into Opening; Step 5: Level Refrigerator - Monogram ZISW36DY Installation Instructions Manual

Table of Contents

Advertisement

3
Step
Install
Side
Panels
4
Step
Roll Unit
into Opening
Decorator
side panels are required wherever the
sides of the refi-igerator will be exposed.
Side panel installation
will be determined
by the
design of the side panel you have previously chosen.
Side panels are normally set into place and fastened
to adjacent cabinetry or the back wall before rolling
unit into opening.
If you choose
to use 1/4" side panels, they should be
fhstened to the refrigerator
before setting refrigera-
tor into place. See Illustration A.
If you choose
to use 1/2" to 3/4"
side panels, see
Illustrations B and C.
1/4 Side Panels – Insert end of side panel
into case trim. Fasten with velcro strips
included.
Illustration
C
l/Z"to 3/4 Side Panels – Recessed front
edge of side panel. Fasten to adjacent
cabinet.
If a custom refi-igerator enclosure
has been made
and installed, or if you are installing between pantry
and oven cabinets, side panels are not required.
Check finished hole size as determined
by previous
instructions.
To
cover entire side of the refrigerator:
Cut panels
84" high, 23-Y16 to 24-3/4"
wide. Height and width
of the panels will vary depending
on installation
method.
Make sure side panels are installed plumb.
See Custom Options Guide for more details.
1/2 to 3/4" Side Panels – Leading edge of
side panel is flush with cabinet front. Fasten
to the back wall using a cleat.
Cabinet'
1/2
t o 3/4 Side Panels – Leading edge of
side panel is routed 1/4 deep, 1-1/2 wide.
Fasten to adjacent cabinet.
With cardboard
protective
pad in position, use a
handtruck
to roll refrigerator
into the front of the
location
cutout.
5
Step
Level
fiftigerator
All
models have 4point
leveling. The front is
supported
by leveling legs, the back is supported
by
rear wheels.
To level the back of the unit, turn the 7/16" hex
Hex Nut
nut located above the front wheels,
Rear Wh
For front leveling, use the 1-1/2" open-end
wrench
(provided).
. Turn hex nut or front leveling leg to raise or lower
the refrigerator.
. Adjust carefully, the refrigerator
should be level
and plumb with cabinetry, and should align with
toekick height.
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents