Adding Ineos Blue To The Device Configuration - Sirona inEos Blue Operating Instructions Manual

Sirona Dental Systems GmbH
Operating Instructions Sirona Dental CAD/CAM System
63 33 632 D3446
D3446.201.02.03.23 07.2011
6.5

Adding inEos Blue to the device configuration

Calibrating the system Adding inEos Blue to the device configuration
"Settings"
1. Click
"Configure Devices"
The
"Add automatically"
2. Click the
"inEos Blue"
(
NOTICE
inEos Blue is not displayed
If inEos Blue does not appear in the
the configuration of the interface (see the section entitled "Checking and
configuring the serial interface").
"Add Device"
3. Click the
The installation is now completed.
Calibrating the system
NOTICE
Calibrating the system
After installing the inEos Blue, you must calibrate the system (see the
chapter entitled "Calibration" [ → 27]).
6 Initial installation of the software
"Configuration" "Devices..."
/ /
dialog box opens.
button and enter a name for this device
is suggested).
"Configure Devices"
button.
in the user software.
dialog, check
21