Operation; Setting The Acquisition System To 3D Camera; General - Sirona CEREC AC BLUECAM Operating Instructions Manual

7 Operation
7.1 Setting the acquisition system to 3D camera
40
7

Operation

7.1

Setting the acquisition system to 3D camera

IMPORTANT
Note relevant only to SW 3.8
These settings only apply to software version 3.8.
✔
To use the 3D camera, the acquisition system must be set to
Handling instructions
camera"
.
✔
You can only execute the following settings if the
"Master Mode"
changed to
1. In the menu line, select the command
"Acquisition system"
"Configuration"
 The
"3D camera"
2. Select
 The 3D camera will remain selected until it is set back to
"inEos"
or .
7.2

General

Aligning the Bluecam
The direction of acquisition must
coincide with the insertion axis of
the preparation prepared by the
dentist.
right
Sirona Dental Systems GmbH
Operating Instructions for the acquisition unit CEREC AC
.
"Settings"
.
window appears.
"OK"
and confirm with .
If the Bluecam is held at an oblique
angle to the prepared insertion
axis, the wall closer to the lens will
be registered with an undercut; the
wall further away from the lens will
be fully displayed, thus causing
the occlusal margin angle to be
presented unfavorably there and
obstructing the automatic margin
detection.
wrong
D3492.201.01.17.02 12.2015
"3D
"Settings"
menu is
"Configuration"
/ /
"Scanner"
62 31 174 D3492