Agilent Technologies B1500A Training Manual page 27

Class Exercise
MOS Id vs Vd Basic Measurement
You will connect the SMU cables and jumper leads
You will then "properly" insert the MOS transistor
You will learn how to load a setup data
Observe Classic Test setup screen
Click
Observe Application Test setup screen
To Get Started:
Use the next several pages as you guide
Verify that four triax cables are connected as shown
Connect four jumper leads to the 28 pin socket as shown
Insert the MOS transistor using the "anti-static" procedure
The purpose of this class exercise is to familiarize yourself with how to connect a MOS FET device,
and make a basic IDVD family of curves measurement. You will observe the Application Test setup
screen and the Classic Test setup screen (interrelationship between the Channel Setup, Measurement
Setup, Display Setup screen).
The next several pages show how to connect the 4-terminal MOS FET used in this course. The
device for this exercise includes a separate substrate pin. This corresponds to the back gate
connection. We can observe all characteristics of the device as if we were probing it at the wafer
level.
button to make a new measurement
5-7
Module 5
Basic Measurement