IBM 3164 ASCII Manual page 182

Planning checklist
Do these sequence of steps before you install your display station (s).
Date Event
Identify the person who will be responsible for all phases of
the planning and preparation.
Review specifications for cables that may not be ordered
from I BM, and gather procurement source information.
Review electrical requirements stated in this chapter.
Make a site preparation plan. Prepare a floor plan showing
the location of the IBM 31 64. Consider the lengths of cables
and power cords.
Order cables from a contractor, if needed.
Arrange for the installation of cables, power receptacles,
wiring, etc.
Define an employee training program, if necessary.
Start the site preparation work according to the plan
previously prepared. Give a copy of the "Physical Planning
Template" on page 6-14 to the person who is preparing the
installation site.
Complete the installation of cables, power receptacles,
wiring, etc.
Complete the site preparation.
Make sure that the site preparation for the end connector of
the modem or the host system and wiring have been
completed.
Fill out the "Setup Sheet" and and "Select Sheet" in
Appendixes A and B respectively, and give it to the person
who is going to set up the display station.
Fill out the "Keyboard Layout Sheet" in Appendix C, and give
it to the person who is going to change the keyboard layout.
Make sure you ordered the necessary accessories.
6-13