IBM 3164 ASCII Manual page 208

{
Select Menu for IBM 3101 Emulation (Canadian French)
OEfIL.-SAUT RETOUR-CR-Lf RET. MARGE AUTO=Ef LF AUTO-EF ENVO'-PAGE SUPP.NULL-EF
If you specify and select
this field this option
DEFIL
SAUr
HF
RETOUR CR-LF*
CR
RET.MARGE EF'
AUTO
HF
LF AUTO EF*
HF
ENVOI PAGE'
lIGNE
SUPP.NUL
EF*
HF
Note:
An asterisk (*) indicates a default
setting.
Selecting the character set (Canadian French)
The Select Character Set command is used for selecting two character sets out of
four. The format for selecting this command is given below.
ESC
<
Pa
ESC> Pa
Parameter:
@: Character Set 1 (ASCII)
A:
Special Graphics
B: Character Set 2
C: Alternate Character
For details on this command, refer to Chapter 5.
After a power-an-reset (POR) sequence, the GO space is selected for Character Set 1
and G1 space for Character Set 2.
The method of selecting the two active spaces GO and G1 depends on the Word
Length option you are presently using; the 7 -bit or the 8-bit word length. The figures
on the following two pages illustrate how this works for the inbound and outbound
operations.
F-9