IBM 3164 ASCII Manual page 123

Chapter 5. Programming considerations
75. Copy Key Command
Down
Control
( Reserved)
o
1
o
This command is used to swap two function keys
ESC space s P1 h P11 P2h P21 (outbound)
Parameter: P1 h.P11·
P2h P21
Source key 10
Destination key 10
The use of these parameters is the same as the
Swap Key command.
This command is used to copy a function from one key to another.
76. Delete Key Command
ESC! s Ph PI (outbound)
Parameter: Ph PI: Key 10 to be deleted.
This command is used to delete a function from the keyboard.
77. Set Default Key Command
ESC" s (outbound)
When this command is received from the host the display station changes the rearranged
keyboard layout to the default setting of the display station.
78. Reset KBD and MDT Command
ESC! S (outbound)
This command is used to un lock the keyboard and reset the MDT bit to 0 after the send/read
operation, if the Lock KBD
&
Keep MDT option is on.
79. Keyboard Lock Command
5-36
ESC: (outbound)
This c.ommand can be used to disable the keyboard as a data entry device,
• until the Keyboard Unlock command is received from the host or
• until the Cancel key is pressed.
Only the Setup, Select Ctrl, Shift, Caps Lock, and Cancel keys are functional when the keyboard
is locked. When locked, KEYS LOCKED appears in the operator information area.
(
(