Table of Contents
Advertisement
2. Enabling the special OSD (on-screen display) menu
3. Checking the current settings
4. Changing the settings
26
a. Press the leftmost OSD button (select / enter) and navigate to the (i)
(information) icon by using the '←'(navigate left) or '→' (navigate right)
button. Press the 'select / enter' button to access the information
screen. The refresh rate and screen resolution will be displayed, as in
this example:
b. Press the 'navigate left' button three times, and then press the
'navigate right' button three times. The special OSD menu will be
display, as in this example:
In this display, the firmware version is shown in the following format:
-1-
aaa
c
ddd
where
aaa:
DDC-CPU version
bbb:
OSD-CPU version
c:
Reserved
ddd:
USB-CPU version
eee:
FPGA-LOGIC version
If the special OSD menu does not appear, press the 'select/enter' button
to exit from the OSD menu. and try again from step 2a.
a. In the special OSD menu, press the 'navigate left' or 'navigate right'
button to show panel 2 of the special OCD menu.
b. In about five seconds, the current EDID settings will be displayed, as
in this example:
If the EDID setting is given as 000, or any number greater than 63, or a
value ending in 'x', an error has occurred; repeat step 3 to try again. For
details, see "Valid setting".
a. From the table in the 'valid setting' section, select the number of the
setting you want to use.
b. Set the brightness level to the number for the EDID setting you have
chosen (see user's guide), you can choose values from 0 to 20. For
higher number, firstly enable the special OSD menu and then exit it by
bbb
eee
Advertisement
Table of Contents
