Table of Contents
Advertisement
2. Getting Started
2. Getting Started
2.1 Power Supply
Supply power to the main unit.
There are two ways to supply power; using AC cord or battery.
-- AC Cord --
Plug the AC cord into the connecting port located under the main power switch on the rear
of the unit.
AC100V~240V power supply line shall be used.
-- Battery --
Charge the battery in advance. You cannot charge the battery when it is installed in the
instrument. (Refer to 6. Battery Charge for charging the battery.)
Open the battery compartment cover on the rear of the instrument. To open the cover turn
the knob around 90 degrees. (Use a coin or something similar to turn it easily.)
Connect the battery to the connecter for rechargeable battery inside the compartment.
To install the battery, align the notch in the battery socket
with the notch on the instrument's battery connector
cable.
Insert the battery as shown on the right picture (the connecter end should go to the rear
of the compartment), and turn the knob back to the original location to close the cover.
After supplying power using the AC cord, switch ON the main power located on the rear
of the instrument. When using battery, turn the switch OFF.
When both the AC cord is connected and the battery is installed, the instrument will
utilize AC power and will not discharge the battery.
www.actoolsupply.com
www.actoolsupply.com
2
Advertisement
Table of Contents
