Kanomax 3900 Operation Manual page 22

3. Display Description and Operation Procedure
www.actoolsupply.com
* When a measurement is
finished, the measurement
point changes from green
to red.
www.actoolsupply.com
Select a measurement point and tap [DETAIL] to
display the details of the selected measurement point.
Tap [START] to start a measurement based on the
setting configured in 3.4 MODE and 3.6 CONFIG.
If "START DELAY" is NOT checked in
"CONFIG" setting:
Upon tapping [START], the pump will begin
running. After the pump has run for 10 seconds to
stabilize, the measurement will begin.
If "START DELAY" is checked in
"CONFIG" setting:
Upon tapping [START] the Delay Time
configured in 3.9.2 CONTROL PANEL –
OPTION – START DELAY begins. During the
last 10 seconds of that Delay Time the pump will
run to stabilize, after which the measurement will
begin.
Tap button while measuring to display a graph.
Tap [STOP] to stop a measurement.
When a measurement is finished, a measurement
result window will be displayed.
Tap [NEXT] to display MAP again. Then the
instrument waits for the next measurement point to
be selected.
Tap [REMEASURE]
remeasuremet.
Tap [PRINT] to print a measurement result.
When all measurements
measurement result will be displayed.
16
button to perform
are finished, the
a