Table of Contents
Advertisement
1. Part Names and Functions
1. Part Names and Functions
1.1 Airborne Particle Counter
FRONT
Outlet
--- Filtered sample air is exhausted at this port.
Do not block the pump as it may result in the
damage to the instrument.
Optional Sensor Connecting Terminal
--- Terminal to connect the optional sensor. Refer to
4. Connecting Optional Extras for details.
Battery Compartment
--- Insert rechargeable battery here. Refer to 2.1
Power Supply for how to install the battery.
Main Power Switch (For AC)
--- Use this switch to turn ON/OFF the main power.
You can also connect the provided AC cord to
supply the power.
USB Connector (Right) **Factory Use Only**
Ethernet Connector (Left)
--- To be used when controlling the instrument by the
software. For details, refer to the operation manual
for the software.
www.actoolsupply.com
Inlet
--- Particles enter the unit here. Attach the
LCD Touch Panel
--- This touch panel allows you to setup and
Paper Cover Open Button
--- Press this button to open the cover when
Printer
--- For printing measurement data. Set the printer
roll-paper here.
Power Switch
--- When the main power located on the rear of the
unit is ON, you can turn ON/OFF the power
using this button.
www.actoolsupply.com
provided standard inlet. To use the provided
isokinetic suction probe, attach Tygon tube on
the end of the standard inlet.
control all instrument functions.
changing the printer roll-paper.
CF Card Insertion Slot
--- Insert the CF card using the provided card
reader to store measurement data.
1
BACK/LEFT
Advertisement
Table of Contents
