Vmm Mounting And Installation - Extreme Networks AP-7562 Installation Manual

The grounding post is located on the bottom of the Access Point above the GND symbol.
WARNING
The grounding cable for an AP-7562 must be at a minimum a #10 gauge wire
cross section.
The grounding cable can be attached to the unit using one of the following methods:
• Use a grounding screw to securely attach the grounding cable to the grounding post.
Use an 8mm socket and driver to tighten the grounding screw to 30 inch pounds (lbf-
in).
• Attach a ring lug to the grounding cable and use a grounding screw to securely attach
the ring lug to the Access Point. Use an 8mm socket and driver to tighten the grounding
screw to 30 inch pounds (lbf-in).

VMM Mounting and Installation

The AP-7562 Vehicle Mounted Modem (VMM) is a software enabled profile within the WiNG
5 architecture that uses the same hardware as the AP-7562 Access Point infrastructure
models.
An AP-7562 Access Point operating as a VMM can be permanently mounted in a vehicle. It
provides mesh backhaul access to a mesh infrastructure network to connect mobile data
terminals, laptop computers, or any other device with either Ethernet or 802.11 wireless
capability. The VMM operates on Power over Ethernet (PoE) and is rugged enough for
AP-7562 Installation Guide
Introduction
15