Access Point Placement - Extreme Networks AP-7562 Installation Manual

• Do not install this equipment or work with its power circuits during thunderstorms or
other weather conditions that could cause a power surge.
• Verify there is adequate ventilation around the device, and that ambient temperatures
meet equipment operation specifications.
• Avoid contact with overhead power lines.
• Take precautions to avoid injury from falling tools and equipment. Crews should wear
hard hats in and around the installation work site.
• Be aware of vehicular traffic in and around the installation work site.
• Do not operate a portable transmitter near unshielded blasting caps or in an
environment where explosives are present unless the transmitter is especially certified
for such use.
• Refer to your site survey and network analysis reports to determine specific
requirements for each deployment.
• Assign installation responsibility to the appropriate personnel.
• Identify and document where all installed components are located.
• Identify and prepare Ethernet and console port connections.
• Verify cable lengths are within the maximum allowable distances for optimal signal
transmission.
CAUTION
The maximum length allowed for PoE cables is 100 meters.
CAUTION
When connecting RJ45 cables, ensure that all cables are connected to the
Access Point from the bottom, and include a drip loop to prevent moisture
intrusion.

Access Point Placement

Observe the following recommended guidelines:
Identify each piece of the mounting bracket and mounting extension arm hardware and
ancillary hardware.
AP-7562 Installation Guide
Introduction
11